Mendota FV-41 Spécifications télécharger pdf (Page 13)

13 | Page

ROUGH FRAMING DIMENSIONS

Rough Framing Dimensions

The Rough Framing Dimensions must be main-

tained to allow this fireplace to slide into the fram-

ing cavity with a 90

elbow installed on the top

starter collar. After the FV-41 Fireplace is inserted

into the rough framed cavity, install one 2x4 on

HDFKVLGHDGMDFHQWWRWKHVLGHRIWKLVILUHSODFH¶V

body and one 2x4 on top of the top framing stan-

doffs to close the air gap and to act as nailing

studs for finishing materials.

If the fireplace is to be recessed in a cavity deeper than 19-´DOOIUDPLQJDQGILQLVKLQJPDWHULDOVSURWUXGLQJSDVWWKH

front face of this fireplace must be of the NON-COMBUSTIBLE variety.

Constructing the Appliance Chase

A chase is a vertical box-like structure built to enclose this fireplace and its vent system. Vertical vents that run on the

outside of a building may be, but are not required to be, installed inside a chase.

Construction of the chase may vary with the type of building. These instructions are not substitutes for the requirements of

local building codes. Local building codes MUST be adhered to.

Chases should be constructed in the manner of all outside walls of the home to prevent cold air drafting problems. The

chase should not break the outside building envelope in any manner.

Wall, ceiling, base plate and cantilever floor of the chase should be insulated. Vapor and air infiltration barriers should be

installed in the chase as per regional codes for the rest of the home. Additionally, in regions where cold air infiltration may

be an issue, the inside surfaces of the chase may be sheet rocked and taped for maximum air tightness.

To further prevent drafts, the fire stops should be caulked with high temperature caulk to seal the gaps. Gas line holes

and other openings should be caulked with high temp caulk or stuffed with unfaced insulation. If the appliance is being

installed on a cement slab, a layer of plywood may be placed underneath this fireplace to prevent conducting cold up into

the room.

Minimum Rough Framing Dimensions

DESCRIPTION DIMENSION (INCHES)

A Width 42-´

B Height 47´

C Depth 19-1/2´ ´*UDQLWH0DUEOH)DFLQJ

D Vent opening height 10-´

E Vent opening width 10-´

Figure 4: FINALIZED Framing Dimensions

19-1/2"

MIN. DEPTH

42-1/2"

FLOOR TO

WALL THIMBLE

CENTER

39-1/4"

FINALIZED

WIDTH

43-3/16"

FINALIZED

HEIGHT

REMOTE RECEIVER

MOUNTING BOX

(2-GANG BOX)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Mendota FV-41 Spécifications Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers Mendota FV-41